Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Front Panel Control
- CHAPTER 6: Remote Operation
- Introduction
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- Logging
- Statistic
- CHAPTER 7: Troubleshooting and Maintenance
- CHAPTER 8: Technical Data
- Index
- Glossary
- Appendix A - Stream State Messages
- Appendix B - Firmware Update
- Appendix C - AES3 Transparency
page 85 of 88Montone.42 Manual - Version 2.0
Appendix B - Firmware Update
Appendix B - Firmware Update
The MONTONE.42 is the mainframe hosting a network module.
Updating Mainframe
The mainframe is updated via USB using the Firmware Update Tool (‘DO Update’).
Visit www.directout.eu and navigate to the MONTONE.42 product page.
Download:
• Installation USB Control - this document will guide you through the necessary
steps
• Firmware MONTONE.42 Mainframe
• Firmware Update Tool
• USB Serial Driver
Updating Network Module
The network module is updated via network.
Visit www.directout.eu and navigate to the MONTONE.42 product page.
Download:
• Firmware RAVENNA Module
Open the control page of the device and navigate to the tab STATUS and click
SETTINGS in the top right corner (p 42).
Click ‘Update’ and browse to the update file after unzipping first.
Example: aoip_hw_4_2_sw_4_7.update
Folllow the instructions displayed.
WARNING!
It is strongly recommended to backup the device configuration (Save Preset)
before running any update.