Manual

page 69 of 88Montone.42 Manual - Version 2.0
CHAPTER 6: Remote Operation
Advanced - Network Advanced Settings
IGMP PORT 1 Defi nition or auto-select of IGMP version used to connect
to a multicast router at port 1.
IGMP PORT 2 Defi nition or auto-select of IGMP version used to connect
to a multicast router at port 2
TCP port HTTP TCP port for HTTP
TCP port RTSP TCP port for RTSP
UDP port SIP UDP port for SIP
TTL RTP packets Time-To-Live of RTP packets - default: 128
DSCP RTP packets DSCP marking of QoS of RTP packets - default: AF41
DSCP PTP packets DSCP marking for QoS of PTP packets - default: CS6*
Multi stream rx If activated, the device allows to subscribe to the same
multicast stream more than one time - default: off
MDNS
announcement
Announcement of streams via MDNS can be controlled
to optimize network traffi c or CPU load.
Values: Off, RX, TX or RX/TX **
SAP announcement Announcement of streams via SAP can be controlled to
optimize network traffi c or CPU load.
Values: Off, RX , TX or RX/TX **
Network settings
Apply
Confi rms and saves changes being made.
Reboot required.
* AES67 specifi es EF, but some implementations use EF for Audio streaming.
To avoid overlapping of RTP and PTP packets in the same queue CS6 has been
chosen as default.
** RX = receive, TX = transmit, RX/TX = receive and transmit
NOTE
Firmware 4.2 / 4.7 introduces Source-Specifi c Multicast (SSM) support for IGMP
v3, v2 and v1 added (SSM via protocol only in IGMP v3, SSM via internal fi ltering is
applied for IGMP v2 and v1) - see “Source Specifi c Multicast” on page 54.