Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Front Panel Control
- CHAPTER 6: Remote Operation
- Introduction
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- Logging
- Statistic
- CHAPTER 7: Troubleshooting and Maintenance
- CHAPTER 8: Technical Data
- Index
- Glossary
- Appendix A - Stream State Messages
- Appendix B - Firmware Update
- Appendix C - AES3 Transparency
page 68 of 88 Montone.42 Manual - Version 2.0
CHAPTER 6: Remote Operation
Advanced - PTP Statistic
Monitoring display only.
PTP state Information about current PTP-clock state:
intialize
error
deactivated
receiving data
pre master
master
passive
not calibrated
slave
PTP jitter PTP-clock jitter in microseconds (µs)
PTP offset Offset relative to PTP-clock master
PTP master to
slave
Absolute offset master-to-slave in nanoseconds
PTP slave to
master
Absolute offset slave-to-master in nanoseconds
Advanced - PTP Clock Setting
No PTP Switch
1 Gbit/s
Adapted PTP-clock algorithm to reduce clock jitter using
1 GB network switches without PTP support.
Max. number of 1 Gbit/s switches: less than 10
No PTP Switch
100Mbit/s
Adapted PTP-clock algorithm to reduce clock jitter using
100 MB network switches without PTP support.
Max. number of 100 Mbit/s switches: 1