Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Front Panel Control
- CHAPTER 6: Remote Operation
- Introduction
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- Logging
- Statistic
- CHAPTER 7: Troubleshooting and Maintenance
- CHAPTER 8: Technical Data
- Index
- Glossary
- Appendix A - Stream State Messages
- Appendix B - Firmware Update
- Appendix C - AES3 Transparency
page 61 of 88Montone.42 Manual - Version 2.0
CHAPTER 6: Remote Operation
Filter
Viewing filters can be applied to focus on used areas for patching.
MADI > NET MADI inputs and NET outputs
NET > MADI NET inputs and MADI outputs
MADI > MADI MADI inputs and MADI outputs
NET > NET NET inputs and NET outputs
Collapse all all i/os collapsed
Expand all all i/os expanded
Patching
• A yellow crossline marks the hotspot for setting a patch.
• Patches are marked be a green square.
• To set a patch
Move the hotspot to the desired position + Click
• To delete a patch
Move the hotspot up to ‚Not Connected - NC‘ + Click
or
ALT + Click the current patch
• Multi-channel patches (diagonal and horizontal):
SHIFT + Click start + Click end
• Multi-channel patches to N/C
ALT + SHIFT + Click start + Click end