Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Front Panel Control
- CHAPTER 6: Remote Operation
- Introduction
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- Logging
- Statistic
- CHAPTER 7: Troubleshooting and Maintenance
- CHAPTER 8: Technical Data
- Index
- Glossary
- Appendix A - Stream State Messages
- Appendix B - Firmware Update
- Appendix C - AES3 Transparency
page 56 of 88 Montone.42 Manual - Version 2.0
CHAPTER 6: Remote Operation
Output Stream Settings
Up to 32 output streams can be sent to the network. Each stream is organized
in a session (SDP = Session Description Protocol) that describes the stream
parameters (audio channels, audio format, packet time, etc.), which can be
adjusted in these settings.
Each stream may be labelled with an individual stream name (ASCII) which is
useful for enhanced comfort at organizing the setup. To start the transmission the
stream needs to be activated.
TIP
Once the stream is active, the SDP data is displayed and may be copied from the
window or downloaded via http://<montone.42>/sdp.html?ID=<stream no.>.