Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Front Panel Control
- CHAPTER 6: Remote Operation
- Introduction
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- Logging
- Statistic
- CHAPTER 7: Troubleshooting and Maintenance
- CHAPTER 8: Technical Data
- Index
- Glossary
- Appendix A - Stream State Messages
- Appendix B - Firmware Update
- Appendix C - AES3 Transparency
page 54 of 88 Montone.42 Manual - Version 2.0
CHAPTER 6: Remote Operation
Manual Setup
Stream name (manual) Stream name for display in status view and matrix.
Can be specifi ed individually, different than the name
gathered from the SDP.
Number of channels Number of audio channels in the stream
RTP-Payload-ID RTP-Payload-ID of the audio stream (Real-Time
Transport Protocol). Describes the format of the
transported content.
Audio Format Stream’s audio format (L16 / L24 / L32 / AM824)
Media Offset Offset between stream’s timestamp and PTP-clock
Dst IP address Multicast IP address of audio stream
SSM Activate Source Specifi c Multicast fi lter for this
stream.*
Src IP address IP address of sending device.*
RTP dst port Stream’s destination port for RTP
RTCP dst port Stream’s destination port for RTCP (Real-Time
Control Protocol)
* An RTP packet contains the IP address of the sender (source IP) and the stream’s
multicast address (destination IP). With SSM activated the receiver only accepts
RTP packets of a certain destination IP that are originated by a sender with the
specifi ed source IP.
NOTE
RTP Payload ID must match between sender and receiver.