Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Front Panel Control
- CHAPTER 6: Remote Operation
- Introduction
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- Logging
- Statistic
- CHAPTER 7: Troubleshooting and Maintenance
- CHAPTER 8: Technical Data
- Index
- Glossary
- Appendix A - Stream State Messages
- Appendix B - Firmware Update
- Appendix C - AES3 Transparency
page 48 of 88 Montone.42 Manual - Version 2.0
CHAPTER 6: Remote Operation
Input Stream Settings
Up to 32 input streams can be subscribed. Each stream is organized in a
‘RAVENNA session’ (SDP = Session Description Protocol) that describes the
stream parameters (audio channels, audio format, etc.).
The stream settings allow to adjust the processing of the received audio data
(offset, signal routing). The receiving of stream data starts once the stream has
been enabled.
The settings displayed vary depending on the selected discovery protocol.
TIP
A sample offset of at least doubled packet time (samples per frame) is
recommended
Example: Samples per frame = 16 (0.333 ms) ➭ Offset ≥ 32 (0.667 ms)
It may be helpful to alter the stream discovery protocol if an expected stream can’t
be discovered by the device.