Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Front Panel Control
- CHAPTER 6: Remote Operation
- Introduction
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- Logging
- Statistic
- CHAPTER 7: Troubleshooting and Maintenance
- CHAPTER 8: Technical Data
- Index
- Glossary
- Appendix A - Stream State Messages
- Appendix B - Firmware Update
- Appendix C - AES3 Transparency
page 43 of 88Montone.42 Manual - Version 2.0
CHAPTER 6: Remote Operation
Manufacturer Settings
Reset
Restore device settings to factory defaults.
Confi rmation required.
Password set/change
Password
Dialog to set or modify the device password.
If the password is lost, access can be regained by resetting to factory defaults at
the front panel.
NOTE
The password must be 8 to 30 characters long and must not contain the
characters <#> and ‚<space>.
L ock Device
To prevent from unauthorized access, remote operation can be restricted to
monitoring display only.