Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Front Panel Control
- CHAPTER 6: Remote Operation
- Introduction
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- Logging
- Statistic
- CHAPTER 7: Troubleshooting and Maintenance
- CHAPTER 8: Technical Data
- Index
- Glossary
- Appendix A - Stream State Messages
- Appendix B - Firmware Update
- Appendix C - AES3 Transparency
page 40 of 88 Montone.42 Manual - Version 2.0
CHAPTER 6: Remote Operation
Network Settings
The two network ports are confi gured individually.
Device name Input fi eld - Module’s name in the network. Used
e.g. for mDNS service. The name needs to be unique
throughout the network.
Dynamic IP address
(IPv4)
Switch to enable the device’s DHCP client.
IP address is assigned by DHCP server. If no DHCP is
available the IP address is determined via Zeroconf.
Static IP address (IPv4) Switch to disable the device’s DHCP client. Manual
confi guration of network parameters.
IP address (IPv4) Module´s IP Address
Subnet mask (IPv4) Module’s subnet mask
Gateway (IPv4) IP address of gateway
DNS server (IPv4) IP address of DNS server
Apply Button to confi rm changes. Another popup window
will appear to confi rm a reboot of the module.