Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Front Panel Control
- CHAPTER 6: Remote Operation
- Introduction
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- Logging
- Statistic
- CHAPTER 7: Troubleshooting and Maintenance
- CHAPTER 8: Technical Data
- Index
- Glossary
- Appendix A - Stream State Messages
- Appendix B - Firmware Update
- Appendix C - AES3 Transparency
page 37 of 88Montone.42 Manual - Version 2.0
CHAPTER 6: Remote Operation
PTP Settings
PTP Input Port selection for PTP clock input. ‘Port 1 & 2’ means
input redundancy.
Mode PTP-clock master / slave confi guration is auto
negotiated between devices in the network.
Module’s master / slave state may change
automatically.
Profi le PTP profi le selection (default E2E, default P2P,
media E2E, media P2P, customized)
Customized profi le Edit opens the tab ‘ADVANCED’ to adjust the custom
profi le.
WCK / VIDEO
WCK / VIDEO
TERMINTATION
Termination state for word clock and video inputs
(off / on)
PTP Settings
PTP Settings