Manual

page 27 of 88Montone.42 Manual - Version 2.0
CHAPTER 5: Front Panel Control
IDLE Screen
The IDLE screen displays two pages for monitoring of:
• PTP-clock
• Status RAVENNA module
Press ‘OK’ to toggle the display between page 1 and 2.
Exit the menu to resume to IDLE screen (left button).
PTP-clock Parameter Values
line 1 (P) clock state Master = Module is master
Slave = Module is slave
line 2 (J) max-PTP-clock jitter per second µ seconds (in slave mode only)
line 3 (O) offset to clock master µ seconds (in slave mode only)
Status
RAVENNA
Module
Parameter Values
line 1 (E) State input stream 1 to 32 <number> solid = stream enabled and connected
<number> blinking = stream enabled, no
connection
* = stream not enabled
line 2 (A) State output stream 1 to 32 <number> solid = stream enabled and connected
<number> blinking = stream enabled, no
connection
* = stream not enabled
line 3 (P) <S> = clock state PTP <S> solid = clock state ok
<S> blinking = PTP-clock jitter > 20µs
<W> = clock state word clock <W> solid = clock state ok
<W> blinking = error, module not PTP master
<W> * = word clock deactivated
<M> = master state <M> solid = module is PTP master
<M> * = module is not master
<S> = slave state <S> solid = module is PTP slave
<S> * = module is not slave
<O> = one switch jitter filter <O> solid = filter is active and ok
<O> blinking = warning - too many PTP packets
with high jitter
<AE> <R> solid = state audio engine Rx (receiver) ok
<R> blinking = errors while receiving audio data
<S> solid = state audio engine Tx (transmitter) ok
<S> blinking = errors while sending audio data