Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Front Panel Control
- CHAPTER 6: Remote Operation
- Introduction
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- Logging
- Statistic
- CHAPTER 7: Troubleshooting and Maintenance
- CHAPTER 8: Technical Data
- Index
- Glossary
- Appendix A - Stream State Messages
- Appendix B - Firmware Update
- Appendix C - AES3 Transparency
page 24 of 88 Montone.42 Manual - Version 2.0
CHAPTER 4: Operation
Sample Rate
The base rate (44.1 kHz, 48 kHz) and the scaling factor (1 FS, 2 FS, 4 FS) of the
main frame is displayed by three leds at the front panel.
SAMPLE RATE
44.1k
LED green - indicates the base rate of the
audio engine.
(OFF) = base rate is different from 44.1 kHz
(ON) = base rate of 44.1 kHz (or multiple of)
is used
SAMPLE RATE
48k
LED green - indicates the base rate of the
audio engine.
(OFF) = base rate is different from 48 kHz
(ON) = base rate of 48 kHz (or multiple of)
is used
SAMPLE RATE
2 FS
LED yellow - indicates the scaling factor of
the base rate.
(OFF) = scaling factor is 1 FS
(ON) = scaling factor is 2 FS
(heartbeat) = scaling factor is 4 FS
NOTE
At higher sample rates the number of audio channels of a single MADI stream is
reduced depending on the integer of the scaling factor:
• 64 channels at 1 FS
• 32 channels at 2 FS
• 16 channels at 4 FS