Manual

page 18 of 88 Montone.42 Manual - Version 2.0
CHAPTER 4: Operation
The green LEDs (PSU 1 & PSU 2) indicate that a working power supply is
connected to the power supply unit. Note that an unlit LED does not guarantee
that the device is free of voltage. To ensure that the device is completely
disconnected from mains voltage, the power chords must be disconnected.
Introduction
This chapter describes the basic operation of the device.
Note that throughout this manual, the abbreviation FS refers to sample rate or
sample frequency. So, when dealing with scaling factors, the following sample
rates can be written as:
44.1 kHz or 48 kHz = 1 FS
88.2 kHz or 96 kHz = 2 FS
176.4 kHz or 192 kHz = 4 FS
CHAPTER 4: Operation
Global Control
The display on the front panel indicates the power supply. The power switches are
on the back panel:
Power 2 Switches
Enable / disable power supply.
Power 2 C13 sockets
Connect the power supply here (84 - 264 V AC).
POWER
PSU1 & PSU2
LED green - indicates state of power supply
(OFF) = power supply not working
(ON) = power supply working
NOTE