Manual

page 18 of 32 MADI.BRIDGE Manual - Version 1.2
CHAPTER 4: Operation
Introduction
This chapter describes the basic operation of the device.
Note that throughout this manual, the abbreviation FS refers to sample rate or
sample frequency. So, when dealing with scaling factors, the following sample
rates can be written as:
• 44.1 kHz or 48 kHz = 1 FS
• 88.2 kHz or 96 kHz = 2 FS
• 176.4 kHz or 192 kHz = 4 FS
The display indicates that a working power supply is connected to the power
supply unit. Note that an unlit display does not guarantee that the device is free of
voltage. To ensure that the device is completely disconnected from mains voltage,
the power chord(s) must be disconnected.
CHAPTER 4: Operation
Global Control
The display on the front panel indicates the power supply. The power switch is on
the front panel:
Power 1 Switch*
Enable / disable power supply.
Power 2 x C13 socket*
Connect the power supply here (84 - 264 V AC).
* The left socket is switched by the power supply switch. The right socket will
power up the device immediately when connected to the mains.
NOTE