Manual

page 23 of 80MA2CHBOX.XL Manual - Version 1.3
Chapter 3: Installation
Do not connect voltage sources to the analog
outputs. This may cause damage at the output
stages. Observe the technical specifi cations listed in
this document.
5. Connect the signal cables for the analog
and AES3 audio signals to the DSUB-9 adaptor.
Connect the adaptor to the DSUB-9 plug at the
rear panel.
The adaptor converts from DSUB-9 (male) to:
• 2 x XLR male (Line Out L/R)
• 1 x XLR male (AES3 output)
• 1 x XLR female (AES3 input).
WARNING!