Manual
Table Of Contents
- About This Manual
- Chapter 1: Overview
- CHAPTER 2: Legal issues & facts
- Chapter 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Remote Control
- Introduction
- Browser Control
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- NMOS - Overview
- NMOS - NIC1 & NIC2
- NMOS - Additional Settings
- Logging
- Statistic
- Switch
- CHAPTER 6: Troubleshooting and Maintenance
- CHAPTER 7: Technical Data
- Appendix A - Wiring Sketches
- Appendix B - Working with BLDS™
- Appendix C - Working with ch 57 mode
- Appendix D - Firmware Update
- Index
page 70 of 93 EXBOX.RAV Manual - Version 1.1
CHAPTER 5: Remote Control
Advanced - Network Advanced Settings
IGMP NIC 1 Definition or auto-select of IGMP version used to connect
to a multicast router at NIC 1.
IGMP NIC 2 Definition or auto-select of IGMP version used to connect
to a multicast router at NIC 2
TCP port HTTP TCP port for HTTP
TCP port RTSP TCP port for RTSP
TTL RTP packets Time-To-Live of RTP packets - default: 128
DSCP RTP packets DSCP marking of QoS of RTP packets - default: AF41
DSCP PTP packets DSCP marking for QoS of PTP packets - default: CS6*
Multi stream rx If activated, the device allows to subscribe to the same
multicast stream more than one time - default: off
MDNS
announcement
Announcement of streams via MDNS can be controlled
to optimize network traffic or CPU load.
Values: Off, RX, TX or RX/TX **
SAP announcement Announcement of streams via SAP can be controlled to
optimize network traffic or CPU load.
Values: Off, RX , TX or RX/TX **
Network settings
Apply
Confirms and saves changes being made.
Reboot required.
* AES67 specifies EF, but some implementations use EF for Audio streaming.
To avoid overlapping of RTP and PTP packets in the same queue CS6 has been
chosen as default.
** RX = receive, TX = transmit, RX/TX = receive and transmit