Manual
Table Of Contents
- About This Manual
- Chapter 1: Overview
- CHAPTER 2: Legal issues & facts
- Chapter 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Remote Control
- Introduction
- Browser Control
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- NMOS - Overview
- NMOS - NIC1 & NIC2
- NMOS - Additional Settings
- Logging
- Statistic
- Switch
- CHAPTER 6: Troubleshooting and Maintenance
- CHAPTER 7: Technical Data
- Appendix A - Wiring Sketches
- Appendix B - Working with BLDS™
- Appendix C - Working with ch 57 mode
- Appendix D - Firmware Update
- Index
page 65 of 93EXBOX.RAV Manual - Version 1.1
CHAPTER 5: Remote Control
Advanced - PTP Unicast
Auto Detect
GM
on = enables the automatic detection of the grandmaster *
off = IP address of grandmaster needs to be defined
manually
Grant duration
(sec)
Time period during which the slave receives sync messages
from the grandmaster.**
Grandmaster IP IP address of the grandmaster. ***
* ‘Auto Detect GM’ is a proprietary function and might not be supported by 3rd
party GMs.
** Depending on the temporary workload of the grandmaster the negotiation may
fail.
*** This value is used only with ‘Auto Detect GM’ set to <off>.
About PTP Unicast
Since the BMCA is not available with PTP unicast, the PTP properties of the
devices require some extra configuration.
Example:
Grandmaster IP Mode Unicast, Mode Master only
Slave(s) IP Mode Unicast, Mode Slave Only,
Auto Detect GM ON, Grant Duration 30 sec