Manual
Table Of Contents
- About This Manual
- Chapter 1: Overview
- CHAPTER 2: Legal issues & facts
- Chapter 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Remote Control
- Introduction
- Browser Control
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- NMOS - Overview
- NMOS - NIC1 & NIC2
- NMOS - Additional Settings
- Logging
- Statistic
- Switch
- CHAPTER 6: Troubleshooting and Maintenance
- CHAPTER 7: Technical Data
- Appendix A - Wiring Sketches
- Appendix B - Working with BLDS™
- Appendix C - Working with ch 57 mode
- Appendix D - Firmware Update
- Index
page 61 of 93EXBOX.RAV Manual - Version 1.1
CHAPTER 5: Remote Control
Patching
• A yellow crossline marks the hotspot for setting a patch.
• Patches are marked by a green square.
• To set a patch
Move the hotspot to the desired position + Click
• To delete a patch
Move the hotspot up to
‚Not Connected - NC‘ + Click
or
ALT + Click the current patch
• Multi-channel patches (diagonal and horizontal):
SHIFT + Click start + Click end
• Multi-channel patches to N/C
ALT + SHIFT + Click start + Click end
• The blue square allows for quick 1:1 patches per port using CTRL + Click and
CTRL + ALT + Click to set all outputs to ‘not connected’.