Manual
Table Of Contents
- About This Manual
- Chapter 1: Overview
- CHAPTER 2: Legal issues & facts
- Chapter 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Remote Control
- Introduction
- Browser Control
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- NMOS - Overview
- NMOS - NIC1 & NIC2
- NMOS - Additional Settings
- Logging
- Statistic
- Switch
- CHAPTER 6: Troubleshooting and Maintenance
- CHAPTER 7: Technical Data
- Appendix A - Wiring Sketches
- Appendix B - Working with BLDS™
- Appendix C - Working with ch 57 mode
- Appendix D - Firmware Update
- Index
page 48 of 93 EXBOX.RAV Manual - Version 1.1
CHAPTER 5: Remote Control
Backup Streams
Example:
Backup stream (input 3) that will act as source in the audio matrix if the current
session (input 1) fails. Switch-over occurs after the defined timeout (1s).
Stream 3 is marked accordingly in the status view
Input 1 failed and Input 3 becomes active after the timeout.
NOTE
In case the main input fails the main stream is stopped (IGMP LEAVE) before the
backup stream is being activated. This behaviour ensures that the required network
bandwidth does not increase in case of a failure.