Manual
Table Of Contents
- About This Manual
- Chapter 1: Overview
- CHAPTER 2: Legal issues & facts
- Chapter 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Remote Control
- Introduction
- Browser Control
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- NMOS - Overview
- NMOS - NIC1 & NIC2
- NMOS - Additional Settings
- Logging
- Statistic
- Switch
- CHAPTER 6: Troubleshooting and Maintenance
- CHAPTER 7: Technical Data
- Appendix A - Wiring Sketches
- Appendix B - Working with BLDS™
- Appendix C - Working with ch 57 mode
- Appendix D - Firmware Update
- Index
page 39 of 93EXBOX.RAV Manual - Version 1.1
CHAPTER 5: Remote Control
Status - Device
Information about the current PSU state, access to settings and preset
management.
Three LEDs inform about the current state of each PSU individually.
PSU 1,
PSU 2,
PoE
LED indicates state of the power supply.
(OFF) = psu not active
(100 % green) = psu active
(blinking yellow) = psu active, after failure*
(blinking red) = psu not active, after being active before*
Settings Opens a popup window to configure the device.
Load
preset
Opens a dialog to store the device settings to a file.
Filetype: .rps
Save
preset
Opens a dialog to restore the device settings from a file.
Filetype: .rps
* To reset the display of the PSU state click on the LED label.
Hyperlinks:
• Settings (p 40)
• Load preset (p 41)
• Save preset