Manual
Table Of Contents
- About This Manual
- Chapter 1: Overview
- CHAPTER 2: Legal issues & facts
- Chapter 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Remote Control
- Introduction
- Browser Control
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- NMOS - Overview
- NMOS - NIC1 & NIC2
- NMOS - Additional Settings
- Logging
- Statistic
- Switch
- CHAPTER 6: Troubleshooting and Maintenance
- CHAPTER 7: Technical Data
- Appendix A - Wiring Sketches
- Appendix B - Working with BLDS™
- Appendix C - Working with ch 57 mode
- Appendix D - Firmware Update
- Index
page 38 of 93 EXBOX.RAV Manual - Version 1.1
CHAPTER 5: Remote Control
Network Settings
The two NICs are configured individually.
Device name Input field - Module’s name in the network. Used e.g.
for mDNS service. The name needs to be unique
throughout the network.
Dynamic IP address
(IPv4)
Switch to enable the device’s DHCP client.
IP address is assigned by DHCP server. If no DHCP is
available the IP address is determined via Zeroconf.
Static IP address (IPv4) Switch to disable the device’s DHCP client. Manual
configuration of network parameters.
IP address (IPv4) Module´s IP Address
Subnet mask (IPv4) Module’s subnet mask
Gateway (IPv4) IP address of gateway
DNS server (IPv4) IP address of DNS server
Apply Button to confirm changes. Another popup window
will appear to confirm a reboot of the module.