Manual
Table Of Contents
- About This Manual
- Chapter 1: Overview
- CHAPTER 2: Legal issues & facts
- Chapter 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Remote Control
- Introduction
- Browser Control
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- NMOS - Overview
- NMOS - NIC1 & NIC2
- NMOS - Additional Settings
- Logging
- Statistic
- Switch
- CHAPTER 6: Troubleshooting and Maintenance
- CHAPTER 7: Technical Data
- Appendix A - Wiring Sketches
- Appendix B - Working with BLDS™
- Appendix C - Working with ch 57 mode
- Appendix D - Firmware Update
- Index
page 19 of 93EXBOX.RAV Manual - Version 1.1
Chapter 3: Installation
The external power supply must be connected to the mains using the three-
cord power leads supplied with the device. Only supply the voltages and signals
indicated (9 - 24 V DC) to the device.
This device may operate with only one power supply. To provide power
supply redundancy, it is recommended to connect both PSU1 and PSU 2
to independent power supplies with separate fuses.
The shipment includes one external power supply unit. Additional power
supply units are available from your local DirectOut representative.
The connected power supply must provide a current limiting to a maximum of 2.5 A.
6. Using the power cord of the external power supply provided, connect the
device to a matching power supply and connect the output of the power
supply to the Hirose connectors at the rear panel.
NOTE
WARNING!
WARNING!