Manual
Table Of Contents
- About This Manual
- Chapter 1: Overview
- CHAPTER 2: Legal issues & facts
- Chapter 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Remote Control
- Introduction
- Browser Control
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- NMOS - Overview
- NMOS - NIC1 & NIC2
- NMOS - Additional Settings
- Logging
- Statistic
- Switch
- CHAPTER 6: Troubleshooting and Maintenance
- CHAPTER 7: Technical Data
- Appendix A - Wiring Sketches
- Appendix B - Working with BLDS™
- Appendix C - Working with ch 57 mode
- Appendix D - Firmware Update
- Index
page 17 of 93EXBOX.RAV Manual - Version 1.1
Chapter 3: Installation
WARNING!
Avoid damage from condensation by waiting for the device to adapt to the
environmental temperature. Proper operation can only be guaranteed between
temperatures of 5ºC and 45ºC and a maximum relative humidity of 80%, non-
condensing.
Ensure that the unit has sufficient air circulation for cooling.
WARNING!
The synthetics of the delivered pads might cause stains on damageable surfaces.
To avoid staining of furniture surfaces it is recommended to place a protective plate
under the device.
Retain the protective cap if the optical port is unused. This will protect against
soiling which can lead to malfunction.
Chapter 3: Installation
Installing the Device
1. Open the packaging and check that the contents have been delivered
complete and undamaged.
2. Place the device on a non-slip horizontal surface. The delivered pads may
be affixed to the bottom of the cabinet. Ensure a clean and dry surface
before affixing the pads.
3. Remove the protective cap from the optical MADI port(s) before use.
NOTE