Manual

page 42 of 94 EXBOX.MD Manual - Version 1.7
CHAPTER 4: Operation
State
The status of the Dante module is monitored by a
LED at the front.
STATE LED - indicates the state of the
Dante module.
(OFF) = module not available
(ON) = module is working
(blinking) = module in failsafe mode*
(blinking) = firmware update running**
* The Dante module starts into failsafe mode if its
firmware is corrupted. This may happen in very
rare cases only. Should you encounter this state,
please contact support for further information.
** After performing a firmware update a power
cycle of the device will be necessary to program
the devices internal flash. This process is
indicated by a blinking rainbow pattern. It takes
about 60 seconds and must not be interrupted.
When finished all LEDs will go dark while the
device is rebooting. To ensure proper operation
another power cycle is recommended - see
'Firmware Update' on page 83.