Installation guide

DirectOut Technologies

M.1k2 Hardware & Installation Guide - Version 1.1

CHAPTER 2: Legal issues & facts

Before Installing This Device

Warning

Please read and observe ALL of the following notes before

installing this product:

• Check the hardware device for transport damage.

• Any devices showing signs of mechanical damage or damage

from the spillage of liquids MUST NOT be connected to the

mains supply, or disconnected from the mains immediately by

pulling out the power lead.

• All devices MUST be grounded. The device is grounded

through its IEC power connections.

• All devices MUST be connected to the mains using the three-

cord power leads supplied with the system. Only supply

electrical interfaces with the voltages and signals described in

these instructions.

• Do NOT use the device at extreme temperatures. Proper op-

eration can only be guaranteed between temperatures of 5º C

and 45º C and a maximum relative humidity of 80 %, non-

condensing.

• The cabinet of the device will heat up. DO NOT place the de-

vice close to heating sources (e.g. heaters). Observe the envi-

ronmental conditions.

Defective Parts/Modules

Warning

This device contains no user-serviceable parts. Therefore do NOT

open the device.

In the event of a hardware defect, please send the device to your

D.O.TEC

representative together with a detailed description of the

fault.

We would like to remind you to please check carefully whether the

failure is caused by erroneous conﬁguration, operation or connec-

tion before sending parts for repair.