Installation guide

DirectOut Technologies

M.1k2 Hardware & Installation Guide - Version 1.1

CHAPTER 3: Installation

Warning

This device MUST be connected to the mains using the three-cord

power leads supplied with the system. Only supply the voltages and

signals indicated (84 V – 264 V).

4. Using the power cords provided connect both PSUs to a

matching power supply:

5. Turn on the power switch and check the status of PSUs on

the front panel:

6. Network integration of the controller - see „Network integra-

tion“ on page 14.

7. Check if the latest ﬁrmware is installed on the device. It is

highly recommended to use the latest version.

To check the ﬁrmware version, open the GUI in a browser and go to

“Misc - Version - System Information”.

For help with the rmware update procedure see „Firmware Update

Instruction“ on page 28.

Keep any packaging in order to protect the device should it need to

be dispatched for service.