Manual

page 30 of 48 ANDIAMO.AES (SRC) Hardware Guide - Version 2.0
CHAPTER 4: Operation
User Bit Routing
The processing of user bits or the whole channel status data can be adjusted for
the output signal. By default the user bit of a single audio channel is processed
depending on the routing; i.e. user bit follows audio.
To set up a ‘MIDI over MADI’ and/or a ‘Serial over MADI’ connection the user bits
of audio channel 56 and/or 1 to 9 are used.
REM LED (green): indicates the use of independent
user bit routing.
LED ON = user bit routing of audio channels 1 to 9
and 56 is preserved for the remote control
protocol - independent from the audio
routing - and passed through from MADI
input to MADI output.*
LED OFF = user bits are processed according to audio
channel routing.
CUVP not implemented
* The setting ‘REM’ is forced once the ‘USB Embedder’ is activated by the
ANDIAMO Remote. The USB Embedder processes remote control data
from USB to the MADI output and from the MADI input to USB. It may be
used to remote control several devices through the MADI signal.
NOTE
Use REM to preserve remote control via MADI while using an individual signal
routing (matrix mode).