Manual

page 25 of 48ANDIAMO.AES (SRC) Hardware Guide - Version 2.0
CHAPTER 4: Operation
If the clock source is set to AES the selection of the AES port as clock source uses
the following pattern in ascending order (port 1, port 2,...):
lowest input port receiving a valid AES signal and SRC switched off
A SYNC LED indicates the sync state for each port individually.
Automatic AES port selection - a change of the AES input signal condition or
changing the activation status of the SRCs may result in a different clock source.
* 16 SYNC LEDs in the metering section indicate the sync state of each AES port
individually. Another 16 SRC LEDs indicate the activation status of the sample rate
converters at each AES3 input port - see „Level Meters - digital I/O“ on page 31.
** The LED SYNC monitors the sync state of the selected MADI input - see
„Clocking to MADI“ on page 27.
Clocking to AES
NOTE