Manual

page 22 of 48 ANDIAMO.AES (SRC) Hardware Guide - Version 2.0
CHAPTER 4: Operation
Blinking LEDs are also used to indicate an error (e.g. missing sync). Concentrate on
the section where one LED is blinking and the remaining LEDs are glowing weak.
Menu Control
All functions of the converter can be accessed using a simple menu. Two pairs of
push buttons are used for navigation and settings.
The upper pair is used to confi gure the signal routing.
The lower pair controls the system settings - clock source, sample rate, analog
levels and MADI output format
See „CHAPTER 5: Menu Navigation“ on page 38.
SELECT Push button
Press longer than 2seconds to enter the menu.
Press short to cycle through the menu.
SET Push button
Only active in menu mode. Press short to adjust a
setting. Press longer than 2seconds to toggle the
Matrix Mode.
When the menu mode is active a LED will blink in one of the sections while the
remaining LEDs of this section are glowing weak.
This indicates:
• a setting can be adjusted in this section
• the blinking LED(s) is the selected option in this section
After a short period of time the menu mode is exit automatically.
NOTE