Manual

page 87 of 140Prodigy.MC Manual - Version 2.4
CHAPTER 6: RAV.IO
Activate stream Stores parameters and activates or deactivates the
receiving of audio data. (Unicast: additionally the
negotiation of the connection)
Stream input Selects one or both NICs used for stream input. Both
NICs means input redundancy.
Backup Stream Selects a backup stream that will act as source in the
audio matrix if the current session fails. Switch-over
occurs after the defined timeout.
Backup Stream Timeout Defines timeout [1 s to 120 s] before switch-over to
backup stream.
Stream name Name of stream gathered from SDP
Stream state Information about stream state:
connected
not connected
receiving data
read successfull
error
Stream state message Status info related to stream state.
Stream state
offset max
Measured value (maximum). A high value indicates
that the media offset of the source might not match
the adjusted media offset of the device.
Stream state
offset min
Measured value (minimum). The offset should not
become negative.
Stream state ip address
src NIC 1
Multicast address of input stream subscribed at
NIC1. Unicast transmission: IP address of sender.
Stream state ip address
src NIC 2
Multicast address of input stream subscribed at
NIC2. Unicast transmission: IP address of sender.
Offset fine Enables adjustment of offset in increments of one
sample.
Offset in samples Modules output delay of received audio data (input
buffer).
Start channel Assignment of first stream channel in the audio
matrix. E.g. stream with two channels, starting at
channel 3 is available at channel 3 & 4 of the routing
matrix.
Discovery protocol Connection protocol or manual setup.
RTSP = Real Time Streaming Protocol
SAP = Session Announcement Protocol
Session NIC 1 Selection of discovered streams at NIC 1
Session NIC 2 Selection of discovered streams at NIC 2