Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Managing Device
- CHAPTER 6: RAV.IO
- Introduction
- Connecting Audio Network
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- NMOS - Overview
- NMOS - NIC1 & NIC2
- NMOS - Additional Settings
- Logging
- Statistic
- Switch
- RAV.IO - Firmware Update
- CHAPTER 7: DANTE.IO
- CHAPTER 8: Troubleshooting and Maintenance
- CHAPTER 9: Technical Data
- Index
- Appendix A - DSUB-25 Pin assignment
- Appendix B - DSUB-9 Pin assignment
- Appendix C - Dimensions
- Appendix D - System Update & License Installation
page 68 of 140 Prodigy.MC Manual - Version 2.4
CHAPTER 5: Managing Device
Shutdown / Reboot into update mode
Both commands can also be used remotely via globcon or the web UI, once the
feature has been activated on the front panel:
This setting is persistent and will be restored after a power-cycle or reboot.
WARNING
Enabling ‘Reboot/Shutdown from remote’ can be a security risk, if the
management network can be accessed freely. It is disabled by default.
To use the new commands in globcon:
• activate the Configuration Mode
• go to Settings - General
You will be prompted to type ‘shutdown’ or ‘update’ to use either command.
Enable Reboot/Shutdown from remote: