Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Managing Device
- CHAPTER 6: RAV.IO
- Introduction
- Connecting Audio Network
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- NMOS - Overview
- NMOS - NIC1 & NIC2
- NMOS - Additional Settings
- Logging
- Statistic
- Switch
- RAV.IO - Firmware Update
- CHAPTER 7: DANTE.IO
- CHAPTER 8: Troubleshooting and Maintenance
- CHAPTER 9: Technical Data
- Index
- Appendix A - DSUB-25 Pin assignment
- Appendix B - DSUB-9 Pin assignment
- Appendix C - Dimensions
- Appendix D - System Update & License Installation
page 43 of 140Prodigy.MC Manual - Version 2.4
Do not connect voltage sources to the analog outputs. This may cause damage at
the output stages. Observe the technical specifications listed in this document.
The line output is not servo balanced. Do not connect the negative lead to ground.
This may cause damage at the output stage. Observe the technical specifications
listed in this document.
The pinout of the digital and analog I/O is different. Check for appropriate cabling to
ensure proper operation and to avoid damages caused by improper connections.
Level Settings
WARNING
To prevent damage from the board only set the jumpers parallel in horizontal
direction - as illustrated above.
NOTE
The analog outputs are fed by the D/A converters and not a split-out of the analog
inputs.
WARNING
WARNING
OK
NO! NO!
15 dBu 18 dBu 24 dBu