Manual

Table Of Contents
page 121 of 140Prodigy.MC Manual - Version 2.4
CHAPTER 7: DANTE.IO
Switch - Configuration
Three network ports are available for transmission of audio signals and remote
control. The built-in network switch can be operated in three modes:
Switched (all ports in the same network)
Redundant (1 = Primary, 2 = Secondary, 3 = Primary)
Red_Sec (1 = Primary, 2 & 3 = Secondary)
The switch will be configured automatically by selecting the respective operation
mode in Dante Controller.
NOTE
If redundancy is being used, secondary interfaces should be connected to a
second separate network. Secondary interfaces cannot communicate with primary
interfaces.
Device Management over the audio network
This configuration is exemplary to illustrate the possibility to integrate the
management data that is used to control the host device into the audio network.
set the switch configuration to ‘Switched’
connect the MGMT port of the device with Port 2 of the DANTE.IO
connect the DANTE network to Port 1 of the DANTE.IO
connect the DANTE network to Port 3 of the DANTE.IO (if needed)
MGMT