Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Managing Device
- CHAPTER 6: RAV.IO
- Introduction
- Connecting Audio Network
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- NMOS - Overview
- NMOS - NIC1 & NIC2
- NMOS - Additional Settings
- Logging
- Statistic
- Switch
- RAV.IO - Firmware Update
- CHAPTER 7: DANTE.IO
- CHAPTER 8: Troubleshooting and Maintenance
- CHAPTER 9: Technical Data
- Index
- Appendix A - DSUB-25 Pin assignment
- Appendix B - DSUB-9 Pin assignment
- Appendix C - Dimensions
- Appendix D - System Update & License Installation
page 117 of 140Prodigy.MC Manual - Version 2.4
CHAPTER 7: DANTE.IO
Network View
The 'Network View' is organised in several tabs. All detected Dante devices are
shown on a list.
The DANTE.IO is delivered with the network interface set to DHCP as a default.
Dante Controller can be used to discover the device on the network and change
the IP configuration if necessary - see “Network Config” on page 120.
Clock Status
The tab ‘Clock Status’ informs about the clock settings of each connected device
and allows to modify them.
‘Preferred Master’ sets the device as PTP Grandmaster in the network
‘Enable Sync to External’ allows to clock the device from an external source that is
defined in the clock settings of PRODIGY - e.g. AES, MADI or internal. The device
shall become Grandmaster of the network then.