Specifications

C-1

C Buep 19e-Expander driverC Buep 19e-Expander driver

C1 First commissioning

Preface The successful parameterization of the PCS as described in the PCS

091/991/925/995 manual is presupposed. This appendix relates

exclusively to the use of the PCS micro/mini/midi and plus together with

the BOSCH CL200/CL400/CL500 PLC via the programming interface by

means of the BUEP19E protocol. In the following, this controller is referred

to as programmable controller and the driver to be loaded into the PCS

as 5P90BUEP. The BOSCH specific terminology and the programming

of the programmable controller with the BOSCH software are presupposed

as known.

Attention!

Use only the software PCSPRO or PCSPRO

WIN

for programming. Other

software packages can release failures of the PCS and PLC.

The following products are required for the operation of a programmable

controller with an PCS (Systeme Lauer company):

1. PCS 009/090/095/900/920/950/950c/PCS plus operating console

2. The PCS 706 connecting cable for the PCS to programmable con-

troller connection via the TTY interface or a zero-modem cable for

the connection via the RS-232C interface

3. PCSPRO floppy disk with 5P90BUEP driver, version 1.3 or later

4. PCS 091/925/995 manual

5. PCS 91.BOS appendix including BOSCH handling software floppy

disk

Furthermore are required (BOSCH company):

1. Programming card, programming cable, software (version 3.12 or

later) and the copy protection device for programming the PLC

2. CL500/CL400/CL200 racks

3. Power supply NT 3

4. Coordinator board SK 500 (not for CL400/CL200)

5. One or several ZS 500 CPU boards (with 32k or 64k RAM module)

6. One or several I/O boards

7. Power supplies for the PCS console and Bosch I/O boards