Automobile Electronics User Manual

➢ Conﬁguring your remote

The remote control has a menu for programming user features. Before you start

make sure the keypad is unlocked. (See Button Auto Lock )

To conﬁgure the remote user features:

Press and hold the 1.

A U

button on the remote for 8 seconds. (ignore the

car indicator at 3 seconds). The remote transmit LED turns on solid to

indicate the Main Menu.

Press and hold the 2. button for 1.5 seconds: The remote LED blinks

two-times. You are now in the Remote Conﬁguration menu. From this

menu you can now conﬁgure the remote's keypad lock features, as

described in the following steps.

Button Auto Lock

When On, the remote Control buttons lock if more than 20 seconds lapses

between button presses. If a button is pressed when locked, the transmit LED

does not light up to indicate that the buttons have been locked. To unlock

the buttons; press the

button followed by the button. The transmit LED

ﬂashes three times to conﬁrm.

Button Auto Unlocking

After turning the ignition off, the remote unlocks the buttons until the next com-

mand is performed. If you do not want Auto Unlocking, it can be turned off by

an authorized Directed Dealer.

Car Select

Car 2 must ﬁrst be turned On (See Remote Features menu in the following Pro-

gramming section to turn on). Press and hold the

button for 3 seconds. The

remote ﬂashes the LED once or twice to indicate the selected Car is 1 or 2,

release the button for Car Select or continue holding for programming. Release

the button, then press and release while the LED is ﬂashing to continue to

perform Car Select. Once the car is selected a command can be performed

by pressing one of the command buttons.