Automobile Electronics User Manual

3
© 2009 Directed Electronics. All rights reserved.
Turn both the unit 2.
front and circuit board
over, remove battery
from clip and replace.
Note: Verify that the bat-
tery polarity is correct
when replacing.
Reposition all parts and snap together.3.
➢ Two car operation
You can use the remote control system for two cars, with full command capabil-
ity for both vehicles.
To change the car selection:
Press and hold the •
A U X
button for 3 seconds until the amber LED blinks
once or twice indicating the current vehicle:
One blink: Car 1
Two blinks: Car 2
To scroll from one car to the other, press the •
A U X
button again. After select-
ing the car, operation resumes. The selected car remains selected until the
setting is changed.
Note: Car 2 mode must be programmed On. See Configuring your remote.
+
+
+
+