Specifications

CAUTIONS

Study your automobile thoroughly before you drill or cut any holes. Take extra care

when working near gas tanks, gas lines, brake or hydraulic lines and electrical

wiring.

Wear eye and ear protection when using power tools. Keep the woofers and

tweeters away from metal filings and shavings. Once foreign objects are stuck to

the magnets or tweeter dome, it will be virtually impossible to remove them. Keep

the tweeters in their protective bags until final mounting to prevent any possibility

of metal dust or chips from passing through the grille and accumulating on the

dome.

Exercise caution when working with the cs series with the grille removed. A slip of

the hand with a screwdriver or other tool can result in irreparable damage to the

cone or dome. Do not touch the cone or dome.

Do not install the components where they will be subject to excessive heat,

moisture or dust, or where they will be kicked or repeatedly bumped or brushed.

Make absolutely sure that the woofer is connected to the lowpass output and the

tweeter is connected to the highpass output of the crossover network. If these

connections are reversed, low-frequency signals will be fed to the tweeter without

fuse protection. In this case, the tweeter may be damaged, such damage is not

covered by the warranty.

When removing or installing the grills be careful not to brush the woofer's rubber

surround or the tweeter's dome with the edge of the grille. Cutting or tearing the

surround or dome will destroy the unit.

Never run wires outside or beneath the vehicle where they can be snagged by

road hazards or the moving parts of the vehicle. Use existing wire channels,

sills, panels and molding strips inside the automobile to hide the wiring for neat

appearance and safety.

Make sure your radio/cassette/cd player and or other equipment is turned off

while connecting the speaker terminals. Turn on the various components and

slowly advance the volume control ONLY after checking and double checking all

connections.

NOTE: If the sound is weak or distorted, immediately turn down the volume and

see the section entitled Troubleshooting.