Specifications

14
(24 mm) apart. Use a 1/8" (3 mm) drill bit for the supplied screws to mount the cup.
The third 1/4” (7 mm) hole is required for the wire to pass through.
Use the template provided to locate the hole centers. Cut carpeting or fabric away
from the hole locations to prevent tangling of fibers in the drill bit.
Surface mount (Straight or Angled)
Mounting slots (qty 4)
#6 x 3/4" screws
(qty 2)
Mounting slots (qty 4)
Insert two #6 x 3/4" flat head sheet metal
screws through the holes in the bottom of
the surface mount cup. Screw the cup in
place. Ensure the mounting screws are
driven in straight, so the heads sit flush on
the cup mounting surface. This ensures the
tweeter will seat properly in the surface
mounting cup. The tweeter is then slid into
the mounting cup (tabs aligned with the
mounting slots), and turned counterclockwise
to lock in place.
NOTE: The mounting cup is also supplied with an angled surface mounting cup
(not shown). This allows the tweeter to be mounted at an optimum acoustic angle
for the listener. Follow the same procedure as above to mount and assemble the
tweeter in this housing.
Flush mount (Surface or Angled)
NOTE: Ensure that there is enough clearance within the interior door panel for the
M4-0.7 X 4-1/2 cm (1.77 inches) flat head mounting screws. Reduce the length of
the mounting screw as necessary to meet clearance.
Mounting slots (qty 4)
Metal mounting bracket
M4-0.7 x 4-1/2 cm
screws (qty 2)
Flush Angled
Mounting Cup
Check the intended installation site
to be sure that there is sufficient
depth behind the mounting surface
for the rear cup and mounting screws.
The minimum depth required behind
the back of the mounting surface is
1" (25 mm). The front cup mounts
into the mounting through a 1-7/8"
(48 mm) diameter hole. Be careful
that the hole does not exceed 2-1/8"
(55 mm) diameter at any point so
that the rim of the cup will completely
cover the edge of the hole.
Use the template provided to locate the hole centers. Cut carpeting or fabric away