Install guide

Rev.: 20111215
Platform: DBALL
Firmware: NISS01
Vehicle CAN Bus Integration System
The Mobile Integration Systems
© 2011 Directed Electronics. All rights reserved.
Nissan Rogue, Sentra & Versa 2009-2011 IPDM-E/R Wiring
Automatic Transmission
30
86 85
87
87a
Vehicles Starter 1 Starter 2 Neutral
Nissa n
Rogue Orange Red Yellow
Sentra White White/Red Brown/Red
Versa 2009-2011 Red White Brown
(+) Starter 2
White
White
Brown
(+) Neutral
(-) Ground
(+) Starter 1
Manual Transmission
(+) Starter 1
Remote
Starter
Page 7
This relay is in the installation
to avoid permanent damage to the vehicle
starter. It also
to protect the relay from water exposure.
REQUIRED
EXTREMELY IMPORTANT
Note that the IPDM may look different on your vehicle, but the connections remain the same.
Component Location in the Vehicle
The IPDM-E/R wiring is located in the driver-
side engine box.
Neutral Safety Wire Voltage Test (Multimeter)
§
§
Key in, Ign. ON, Transmission in Park or Neutral: 12 volts.
Key in, Ign. ON, Transmission NOT in Park or Neutral: 0 volt.
Automatic Transmission
Three (3) available stages:
Key in, Ign. OFF: 0 volt.
§
Starter Wire Voltage Test (Multimeter)
Two (2) available stages:
Key in, Starter motor NOT engaged: 0 volt.
§
§
Automatic & Manual Transmission
Key in, Starter motor engaged: 12 volts.