Specifications

5. If possible, route the transducer cable away from other wiring on the

boat. Electrical noise from engine wiring, bilge pumps and aerators

can be displayed on the sonar's screen. Use caution when routing the

transducer cable around these wires.

Good and poor transducer locations.

How low should you go?

For most situations, you should install your Skimmer transducer so

that its centerline is level with the bottom of the boat hull. This will

usually give you the best combination of smooth water flow and protec-

tion from bangs and bumps.

CAUTION: Clamp the trans-

ducer cable to transom near

the transducer. This will help

revent the transducer from

entering the boat if it is

knocked off at high speed.

Good location

Poor angle

Poor location

Good

location