Installation guide

© 2006 directed electronics
39
blackjax feature
blackjax activation sequence
When BlackJax is programmed ON, BlackJax sequence will begin every time the igni-
tion is turned on and must be turned off by entering your PIN code. It will then acti-
vate again while driving when triggered as described below.
NNOOTTEE::
BlackJax can be turned off by entering PIN code at any time. 1.
Ignition on.
z
System sees input on Zone 7 ignition input.
2. Door Open & Close.
z
System sees input on H1/8 or H1/9 Door trigger input.
3. Press and release brake pedal.
a. System sees (+) input on H2/11 BROWN/WHITE brake input/output wire.
b. System then begins monitoring input on H1/4 VIOLET/BLACK wire or
Intellistart 4.
c. System sees RPM at or above 2 x programmed rate, BlackJax begins 20
second countdown.
4. After a 20 second countdown:
a. 5 siren chirps as reminder to enter PIN code.
b. Brake light relay pulses (+) 12v on H2/11 BROWN/WHITE to flash brake lights.
c. You then have 20 more seconds to enter PIN to turn off Blackjax.
5. If PIN code is NOT entered within 20 seconds:
z
System sounds siren and begins flashing parking lights.
z
Brake lights continue to flash.
z
The system will now immobilize as described in steps 6-7.
6. If system sees the RPM rate return to 1 ½ times programmed RPM rate or lower,
the system will immobilize the vehicle as described in step 7.
7. Vehicle Immobilization:
z
immobilizer will engage the starter and ignition circuits.
z
The siren will continue to sound and the parking and brake lights will flash
for a maximum of 5 minutes.
z
Immobilization circuits will remain active until correct PIN code is entered.