Operating instructions

3
Index
EC Conformity declaration 4
1. Machine dimensions 5
1.1 D2000 5
1.2 D2400 5
1.3 D3000 6
2. Delivery and installation 7
3. Conditions for best results 7
4. Overload protection 8
5. Safety instructions 8
6. Start-up and maintenace 9
6.1 Electronical equipment 9
6.2 Start-up 9
6.3 Maintenance 9
6.4 Lubrication 10
6.5 Initial cleaning of the machine 10
6.6 Headstock 11
6.7 Cross support 11
6.8 Tailstock 12
7. Speed regulation 13
7.1 Speed selection 13
7.1.1 Speed setting for working with aluminium 13
7.1.2 Speed setting for working with steel 13
7.1.3 Speed setting for working with brass, copper 14
7.2 Speed change 14
8. Applications 15
8.1 Longitudinal and transverse turning 15
8.2 Thread cutting with automatic feed 16
8.2.1 General note 17
8.2.2 Application of change gears 17
8.2.3 Altering the feeds or thread pitches for D2000, D2400 19
8.2.4 Altering the feeds or thread pitches for D3000 21
9. Pair of toothed wheels for left-hand thread cutting 22
10. Angle plate with milling table 23
11. Lubrication coolant unit 24
12. Declaration of noise levels 25
13. Drawings and list of parts 26
13.1 Headstock 26
13.2 Support with motor and protective cover for D2400 und D3000 27
13.3 Lead screw drive for D2000 and D2400 28
13.4 Lead screw drive for D3000 30
13.5 Drive with gear transmission for D2000 32
13.6 Cross support 34
13.7 Tailstock 36
13.8 Rear bearing with guide rods 37
13. Circuit diagram 38
13.1 Circuit diagram for D2000 and D2400 38
13.2 Circuit diagram for D3000 39