Operating instructions

10. Angle plate with milling table

For drilling and milling

The milling function serves for machining flat surfaces

and grooves. When milling with the angle plate the

feed motion is effected from the workpiece. If the

angle plate is mounted correctly to the cross support

(see assembly instructions), the work piece can be

rigidly and firmly attached to the clamping plate. It

should be clean of dirt and chips beforehand in order

to guarantee a good rest. The clamping screws used

are inserted into the T-slot of the clamping plate. In

addition, a machine vice can be attached to the

clamping plate. The tool is to be clamped as short as

possible into the collet (danger of breakage). If the

tool is firmly clamped, the depth adjustment is done

via the feed shaft.

Assembly of the angle plate with milling table

At first remove the longitudinal support from the transversal support of the lathe. Then the angle

plate is screwed to the carriage of the transversal support with the delivered hexagon screw.

After removing the clamping plate and the spring from the longitudinal support, mount the

longitudinal support to the angle plate as indicated below. The angle plate (milling table) is clamped

to the pivot pin of the transversal support by using the two lateral tap bolts. In a final step the dust

guard is to be put in the centre bore of the transversal support.