Installation manual

1
v5.3 (40027)
©
2005 Directed Electronics, Inc.
Tools required to install the AutoCommand
®
Unit:
Wire Cutters/Strippers
Soldering Iron
Pliers
Testmeter
We highly recommend that all connections be soldered for reliability.
Parts List included with the AutoCommand
®
Unit:
Remote Starter Receiver Module
Transmitter
Antenna with Custom Clip
Control Harness (6 position)
Keyless Entry Harness (4 position)
6 Power & Ignition Wires
Yellow Headlight Wire
Alcohol Pad
Green 30 A Fuse
On/Off Control Switch
Ring Terminal
Hood Pin Switch Set
2 Cable Ties
Yellow Butt Connector
Remote Car Starter Installation Manual for Model 40027, 40027T
PLEASE READ COMPLETELY BEFORE BEGINNING
Congratulations on your purchase of the AutoCommand
®
Remote Car Starter. AutoCommand
®
Remote Car Starter allows you to start the car by remote
control from the comfort of your home or office in order to cool it down in the summer or heat it up in the winter.
AutoCommand
®
is for automatic transmission, fuel injected gasoline vehicles only. Please see pages 6-7 for important information about vehicles with
factory anti-theft systems. AutoCommand
®
is an extremely sophisticated system with multiple built-in safety and security features.
AutoCommand
®
Remote Car Starter:
Will not let the car be driven without the key in the
ignition.
Shuts itself off automatically after 10 or 15 minutes
(programmable) if you forget to come out to your car.
Will shut off if the brake pedal is pushed, the hood is
opened, or the transmission is shifted out of park - unless
the key is in the ignition and in the “run” position.
Protects your vehicle with a basic alarm system.
Is quality engineered and microprocessor controlled to
provide many years of reliable use.
Comes with a Limited Lifetime Warranty.
Will start your car by remote control, and run the heater,
defroster, or air conditioner to warm up or cool down the
car.
Is designed to start the car if it is in park, and only if the
hood is closed.
Has Lock, Unlock and Trunk Pop keyless entry features.
Will attempt to start the car for up to six seconds, but no
longer (to avoid damage to the starter motor). Should the
car not start, or if it stalls after starting, the remote starter
will make two further attempts to start it.
Alchohol
Pad
Warning Label
2 Protected by
DesignTech Labels
The following parts are included in the plastic bag:
www.designtech-intl.com • www.directed.com • 800-876-0800
* For free vehicle specific wire information, consult
our website at www.designtech-intl.com
Color Function Circuit Type Required
White/Red Unlock (+/-) 400 mA Output No
Gray/Black Alarm Input (-) Input No
Purple Hood Switch (-) Input Yes
Orange Brake (+) Input Yes
Blue Horn (-) 400mA Output No
Circuit
Color Function Type Required
Pink Power (+12V) Input Yes
White Accessory Relay output Yes
Yellow Starter Relay output Yes
Blue Ignition 1 Relay output Yes
Green Ignition 2 Relay output Consult Wiring Guide*
Black Ground Input Yes
Small Yellow HeaLights Relayoutput Optional
Power Harness
Color Function Circuit Type Required
Green Tach (-) Input No
Brown/White Alarm Disarm (–) 400 mA Output Consult Wiring Guide*
White/Black IGN 3 (–) 400 mA Output Consult Wiring Guide*
Green/White Trunk (-) 400 mA Output No
Yellow/Red Lock (+/-) 400 mA Output No
Control Harness
ON/OFF Switch Jack
Coax
Antenna Jack
Electrical Tape
Screwdriver
Drill with
1
/4”and
5
/16
drill bits
Wiring Diagram

Summary of content (20 pages)