Remote Starter User Manual

ManualsBrandsDirected Electronics ManualsRemote StarterAS-1775

5BUTTONAUTOMATIC/MANUALTRANSMISSION

REMOTESTARTER



INDUSTRY CANADA USER NOTICE:

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)

this device must accept any interference, including interference that may cause undesired operation of

the device.

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen

that the equivalent isotropically radiated power (EIRP) is not more than that required for successful

communication.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized

modifications to this equipment. Such modifications could void the user's authority to operate the

equipment

AS-1775

User Guide

WARNING

It is the responsibility of the vehicle operator to ensure that their

vehicle is parked in a safe and responsible manner.

1. a) Manual transmission: When leaving the vehicle, it is the user’s

responsibility to ensure that the gearshift lever is in the NEUTRAL

position and the parking brake is engaged in order to avoid accidents

upon remote starting.

b) Automatic transmission: When leaving the vehicle, it is the user’s

responsibility to ensure that the gearshift lever is in “Park” in order to

avoid accidents upon remote starting.

(Note: Make sure that the automatic vehicle cannot start in "Drive".)

2. It is the user's responsibility to ensure that the remote starter is disabled

or put into valet mode before servicing.

Designed & engineered in Canada

Summary of content (13 pages)

PAGE 1
5BUTTON AUTOMATIC / MANUAL TRANSMISSION REMOTE STARTER AS-1775 User Guide WARNING ! It is the responsibility of the vehicle operator to ensure that their vehicle is parked in a safe and responsible manner. 1. a) Manual transmission: When leaving the vehicle, it is the user’s responsibility to ensure that the gearshift lever is in the NEUTRAL position and the parking brake is engaged in order to avoid accidents upon remote starting.
PAGE 2
Table of Contents Government regulations .................................................................................................................. 3 Introduction .............................................................................................................................. 3 Using the Remote Control ............................................................................................................... 4 Vehicle Presets .......................................................
PAGE 3
Government regulations This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 4
Using the Remote Control Your Remote Car Starter is equipped with a 5-button multi-channel remote control. It can operate two independent vehicles equipped with a Remote Car Starter (see Multi-Car Operation page-12, for second-car transmitter functions). The functions of the transmitter are as follows: Picture serves as example only. LOCK: Locks the doors and arms the STARTER KILL.
PAGE 5
The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm automatically) or Active Mode (so as to require the user’s intervention for arming). By default, your Remote Car Starter is configured to Passive Mode. Passive mode: To arm the Starter Kill, press the button on the transmitter, OR 1.
PAGE 6
pedal. Make sure to release the brake pedal. The parking lights will flash 3 times quickly and remain lit. Skip to step 4. 3. Within 20 sec. of engaging the parking brake, press and hold , or on the transmitter. The parking lights will flash 3 times quickly and remain lit. 4. Remove the key: the engine will continue running. 5. Exit the vehicle and close all doors, hood and trunk. 6. Press for approx.
PAGE 7
Remote Trunk Release If your system was installed with the Remote Trunk Release option, you can open your trunk by pressing the button for 3 seconds on the remote transmitter. Idle Mode Convenience feature: Idle Mode allows you to keep the engine running and the doors locked while you stop, for example, at a convenience store or for a short delivery. This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the Ignition Switch) while the engine is running.
PAGE 8
1. 2. Press the and buttons simultaneously until the parking lights flash three times. The LED on the antenna will come ON solid to indicate that the vehicle has successfully entered Valet mode. To put the system out of Valet Mode To put the system out of Valet mode using the KEY (Ignition Valet Mode): 1. Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times successively into the IGNITION/RUN and OFF positions. 2. The parking lights will flash twice. 3.
PAGE 9
• Turn the ignition key to the IGNITION ON (RUN) position. • Press and hold the button until the parking lights come ON for 2 seconds, pause, and then flash once. If Safe Start is enabled, you can activate Cold Weather Mode by: • Pressing and releasing the button, then, pressing and holding the button until the parking lights flash 3 times.
PAGE 10
Advanced Features: Installationprogrammable Options The Remote Car Starter was designed with flexibility and OEM integration in mind. With its programmable options, this unit can single-handedly control nearly any electrical system in your vehicle. Caution: The programming of your system should be left to a professional. Changing any one of the settings may affect the operation of your Remote Car Starter. Please note that the following programmable options may require additional parts and labor.
PAGE 11
4. 5. Press the button; this will lock the doors, arm the OEM-style alarm (if configured|) and confirm that the vehicle is in Turbo Mode. The engine will shut down after 60 seconds. If your vehicle has a manual transmission, follow all steps of the Ready Mode routine (page-5) to activate Turbo Mode. At the last step, press either: • • • to lock the doors and have the engine shut down after 60 seconds; The parking lights will flash 3 times and remain lit.
PAGE 12
activated, panic mode is enabled. If horn confirmation is disabled, panic mode will not be available. Horn Chirp Timing The pulse duration can be configured by your installer (from 5 ms to 200 ms). Multicar Operation This option allows the owner of two vehicles, both equipped with the same Remote Car Starter model, to control both systems with a single remote control. To control the second vehicle, simultaneously press the TRUNK button and the button of the function you wish to use.
PAGE 13
Troubleshooting Poor Transmitting Range Many factors may affect the operating range of the transmitter. Some of these are: • • • • • • • • The condition of the battery in the transmitter. The operating environment (for example: downtown radio-frequency noise, airports, cellular phone towers…). Metal: any type of metal will affect operating range. This includes the vehicle itself. The shape of the vehicle can affect range as well (vans in general have less range).