Security and Remote Start Owner's Guide

37
© 2008 Directed Electronics. All rights reserved.
Feature Opt 1 Opt 2 Opt 3 Opt 4 Opt 5
Button press
beep
On
Off back
System type Remote start
& Security
Remote start Back
Clock set
Clock time
Back
➢ Menu option descriptions
Auto keypad lock•
Automatically locks the remote buttons when the buttons are not used for
60 seconds. Prevents “accidental” presses of the remote.
Press
A U X
then
A U X
to unlock the keypad.
Note: If the auto keypad lock feature is programmed On, the remote auto-
matically unlocks when the vehicle ignition is turned Off. The remote stays
unlocked to allow time to exit and unload the vehicle, and then lock the
doors with the remote. When the
A U X
button is pressed, the keypad auto
lock feature resumes normally.
Page On or Off and Power save•
When paging is “On” the remote checks the status of the system every
four seconds, and reports any alarm triggers (if the system is within the
operating range).
In the paging “Off” setting, the remote does not check the status of the
system. In the paging Off mode the remote will only beep and report when
a button on the remote is pressed.
In the “battery saver” mode, the remote goes into sleep mode if no buttons
are pushed for 72 hours. The timer resets each time a button is pressed.
Page Alert / Vibe/Beep Tone/Both or /Screen only•
Receive command confirmations on the remote with vibrations, beeps or
both, or with display only.