Security and Remote Start Owner's Guide
33
© 2008 Directed Electronics. All rights reserved.
will shut down when locking).
Press the 3.
A U X
button on the remote 3 times and then press the
A U X
button.
The 2 way remote will beep once and flash the 4.
A U X
LED once.
The parking lights on the vehicle will flash 5 times fast confirming 5.
entry into smart start mode
The vehicle will now remote start when the cabin temperature 6.
reaches the programmed thresholds or when the vehicle battery
reaches the programmed voltage.
The Smart Start Mode can be exited by following the activation proce-
dure with the remote or can be deactivated manually by turning on the
ignition or pressing the brake pedal in the vehicle. The parking lights
will ash 5 times slow conrming that Smart Start Mode is exited.
Details:
Smart start uses temperature and voltage settings to determine
when the vehicle should start and run. If any changes to temperature
or voltage are made using the Bitwriter programming tool Smart start
activation is affected.
The Smart Start function works similar to the Timer mode. The system
must be in the locked mode, and using the system default settings, it
has a maximum of 6 starting cycles and checks the voltage/cabin
temperature every 3 hours to see if the thresholds have been met.
If thresholds have been met then the remote start will start the vehicle
and run for the pre programmed time. It counts the first start as one suc-
cessful start, leaving 5 start cycles.
If the threshold has not been met then the system will not start the ve-
hicle, and 6 start cycles are left. The unit continues to check threshold
levels every 3 hours.