Installation guide

57
© 2008 Directed Electronics. All rights reserved.
7 flashes Timer mode/Turbo mode/Manual mode error *
8 flashes Neutral safety shutdown
9 flashes Low battery (voltage mode)
10 flashes Alarm triggered **
11 flashes Wait-to-start input timed out
* Timer mode error: Ignition is on or shutdown input is active when activating
timer mode.
Turbo mode error: Turbo mode is programmed off, engine is not on or
shutdown input is active.
Manual mode error: MTS mode not enabled.
** Alarm was triggered during remote start sequence.
Remote starting diagnostics
When the remote start function is activated and the 2-way remote emits an error
tone; you have the ability to see what the cause of the no-start situation is by
counting the amount of flashes of the parking lights from the vehicle.
5 flashes Brake wire is active
6 flashes Hoodpin wire is active
7 flashes Manual transmission mode is enabled and not
initialized.
8 flashes Neutral safety wire has no ground or the neutral safety
switch is Off.