Installation guide

“times out” when the remote start activates in timer mode. The system may be

shut down using a shutdown at any time. Using the Bitwriter®, the run time can

be programmed for any duration from 1-16 minutes.

3-8 Flex Relay Function:

Ignition 2 (1)

In the factory setting, the ﬂex relay func-

tions the same as the pink ignition 1 wire, in accessory (2) setting the ﬂex relay

functions the same as the Orange accessory 1 wire, in starter (3) setting the ﬂex

relay functions the same as the purple starter 1 wire.

3-9 Diesel Timer—Wait-To-Start Input

(1)

- 15 (2), 30 (3), or 45 (4) seconds.

Default is the “Wait-to-Start” input control wire, or programmable to ignore

the input control wire by a delay of 15 ,30, or 45 seconds. This feature can

also be optionally programmed with the Bitwriter®, with a delay from 1 to 90

seconds in one second increments.

3-10 Accessory State During Wait-To-Start: On (1)

OFF (2): This feature allows

the selection of the accessory output to be ON or OFF during wait-to-start. Use

the two-chirp setting for OFF.

3-11 2nd Status Output: Normal (1)

Latched (2) Pulsed (3): This feature allows

selection of status output or a rear defogger mode that turns on ten seconds after

the vehicle has started if the vehicle interior temperature is below 55 degrees F.

The defogger mode has two selections, latched, or pulsed. Latched mode only

stays on for 10 minutes.

Note:

When the defogger mode is on, the output is always active and can

be turned on independently with the remote for a one-time activation. (See the

Remote Functions table.)

3-12 Parking Lights: Constant (1)

Flashing (2) OFF (3)

In the default setting, the

parking lights (if connected) comes on solid during the remote start runtime. In

the two- ﬂash setting the parking lights ﬂashes during the remote start runtime. In

the OFF setting, the parking lights do not come ON or ﬂash, when the vehicle

is remote started.

3-13 Anti-Grind: On (1)

OFF (2)

With the anti-grind On (default) the ground-

when-armed output is active during remote start operation. This activates the

starter kill relay and prevents the customer from re-cranking the car with the key,

when doing key takeover. If accessories such as a voice module or window